![]() Whenever you dye, use a hairdryer to dry it. Up to five treatments may be necessary, depending on the severity of the crack.Įvery time you apply the dye, rub the crack’s surrounding area to blend it in. If necessary, apply several coats of dye to the cracks. To prevent the leather from drying out, blow a hairdryer back and forth along the cracks for two minutes to let the dye dry. Make sure the dye is evenly distributed throughout the cracks. With a colour-fast sponge or applicator pad, apply a thin coat of dye over the cracks. Pick a leather dye that closely matches the colour of your item. Remove any dirt and dust that may interfere with the absorption of the colouring. Rubbing gently along the leather’s grain will make it smooth. The leather must be sanded and wiped clean before dyeing. Prepare the surface with filler.Īpply leather filler, if necessary, by following the steps above. Applicator pads or sponges that fasten colour.Method 2: Blending cracks with leather dye A further layer may be necessary as the filler dries. It is, however, important to avoid direct sunlight and direct heat as these factors can further dry out the leather. The leather will dry faster in a properly ventilated room or the open air. To ensure solidification, this step must be taken. Repeat this process until you no longer see any overspill. Remove the excess paste with the knife.īy tilting the palette knife sideways, you can gently scrape off the excess paste. Until it appears that the crack is filled, apply more. Apply leather fillerĪpply the filler with a palette knife, then fill in the cracks with the paste by brushing it in. Tip: Avoid coarser, harsher sandpaper as it will leave scratches. Once you’ve reached a finish that looks smooth, then stop. SmoothĪpply gentle pressure to the cracks as you wear them down with super-fine sandpaper. To ensure faster drying, wipe off any moisture with a dry cloth. It is important not to let the leather get wet since moisture will prevent the filler from settling in the cracks. Ensure you test the cleaner first on a small area, then mix the soap with water. If any dirt remains on the leather, wash it off with a cloth or sponge dipped in soap. Here are two methods for treating more deep-seated damage. It should prevent further drying and crack of the product. ![]() Reapply leather conditioner every month for best results. It is important not to over-oil leather because this can collapse the structure, making it appear waxy and slippery. You may have to repeat the application if the leather seems too dry. Let the leather dry completely, preferably overnight, so it can absorb the conditioner and rehydrate. Let the leather naturally dry after wiping off the excess product. Continue to do this until the crack is visibly less pronounced or deep. Use your finger, sponge, or back of a spoon to smooth the crack. Once you’ve tested it on a small patch, apply the conditioner or oil to the crack. The goal is to get the leather soft and flexible. Then, use a small, fine-bristled brush and mild soap to clean the cracks more thoroughly. Use a soft, dry cloth or brush to clean the top surface of the cracks and the leather surrounding them. You should test the cleaner or soap on a small patch first.
0 Comments
Leave a Reply. |